Installation Guide

Install TIC With Confidence

Before you begin, gather basic hand tools, read the safety checks, and confirm the pipe diameter. The steps below walk you through a clean, leak-free fitting.

Before You Start

Prepare basic hand tools for loosening clamps and securing couplers. Confirm the intake pipe diameter matches the TIC unit, and ensure the engine is cool and switched off.

Step by Step

Sequential Installation Steps

01. Disassemble the Intake Duct

Loosen the clamps on the factory intake ducting and carefully remove the existing pipe section.

02. Position the Unit

Set the TIC unit in place, keeping the inlet and outlet aligned with the surrounding ducting.

03. Align the Connections

Check that every connection sits square and straight before tightening any component.

04. Clamp the Silicone Couplers

Secure each silicone coupler with its clamp, tightening evenly so the joint seals without distortion.

Verify the pipe diameter before installation, then run a leak-free coupling check at every joint before starting the engine.— TIC Fitment Reminder